Holiday Alarm Thresholds

A holiday alarm should be set when the water use will be abnormal for a period of time, for example if you are away on holiday (lower than normal water consumption), or if you know you’ll be filling up a swimming pool on a certain day (higher than normal water consumption).

The holiday alarms will override any others set, and only be active within a chosen time range.

For example:

A permanent alarm is set at 20 mins of  water flow, and a holiday alarm is set for 1st Jan at just 5 mins of water flow. If a leak starts at 1pm on 1st Jan, an alert would be sent at 1:05pm (not 1:20pm) because of the holiday alarm.

To set a holiday alarm:

• In the settings page, click on the "Configure Leak Detection" button.
• Click the “Holiday Mode” button in the alarms section of the settings page of your device. This takes you to the “Holiday Alarms” page.
• In the “Create New Alarm” section, set the “Start Time“, “From” date, “To” date, “End Time“, Alert and Shut off values.
• Click “Save“.

You will now see the newly created alarm details in the displayed table. Up to 15 holidays can be stacked up, which will be stored in the device’s memory offline too.

At any point, you can adjust the values more precisely – just click “edit” and type the desired numbers in.

Alarms can be deleted by checking the box next to each alarm and then clicking the “Delete” button.